Normal maintaince of leather spraying machine:
1.Remove the friction plate, plywood
1) First: Open the power switch
2) Disassemble the spraying machine into the duct , spraying pipe, and discharging mouth
3) Gradually dismantal leather spraying machine feeding sieve, poking teeth, a storage box, allocated material tooth
4) Loosen the two hold-down bolts and vertex Angle bolts, pull down the old plywood
5) loosen the feeding box four tighten bolts, pull down on the container and the container
6) using a wrench, loosen the swivel shaft nut off to damage the friction disc This completes the friction disk of shotcrete machine, plywood disassembly.
2.Install the friction plate, plywood
1) After twist is clean, the new friction disc alignment of eye level on the swivel
2) the pressure of big shaft nut, ensure the swivel with no gap between friction disc
3) Installed in turn on the upper container, down container
4) Put new plywood with discharging mouth in plywood fixed position
5) good compaction pressure bolt and fixed vertex Angle bolts
6) in order to install the shotcrete machine dial material ejecting teeth on the tooth, container, storage, loading a sieve
7)Leather Spaying machien is installed into the duct and the spraying pipe.
This completes the friction disk of leather spraying machine , the installation of plywood, good shotcrete machine maintenance.
Contact: Tingting Lu International Line:+86 13915075937
Add: 118-68 Xinchang Road, Xinzha Town, Changzhou , Jiangsu, China.